Oops, an error
Loading. Please wait.

Flower Chords

version 1
version 1

Whole song

26,698 views 57 this week
3 commentsread comments
1 2 3 4 5
accurate
x 12
add to favorites
launch autoscroll
font size
0
reset
transpose
0
reset
simplify chords
display chords
guitar tuner
Tab Pro tools
  • play this tab
  • loop segment
  • change instrument
  • show fretboard
  • metronome
×
Best way to learn
"Flower"
Autoscroll
slow
fast
+/-
esc
set tempo
stop
Contributor
Difficulty
Capo
intermediate
7th fret
Artist: Amos Lee
Song:   Flower
Album:  Mission Bell

Because I have not found it anywhere else I have decided to make my own chords of this song.

h = hammer on
x = muted

(Capo 7 frets relative to capo)

   A        A/E          F#m   F#/D
-----0-0-----------------------2-3-3-2-x--2-2-0-0---|
---3-3-3---0h2-----2-----------3-3-3-3-x--3-3-3-3---|
---2-2-2---0h2--x--2--x--------0-0-0-0-x--0-0-0-0---|
---4-4-4---4-4--x-----x--------x----------x-x-x-x---|
---5-5-5---5-5--x-----x---2----2----------2-2-2-2---|
--------------------------0-------------------------|

It is just the same pattern repeating over and over.
(Be sure to listen to the song a lot to get the timing down)

Tabbed by DoodlySquat, enjoy :)
comments
print report bad tab
3 comments total.
0 reply
DoodlySquat wrote on June 9 2011, 02:42 pm

Please rate! :)

0 reply
YOURMOMSGUITAR wrote on December 20 2011, 03:31 pm

Nice I've been looking for this I don't see why it is four stars I can't find anything wrong with it.

0 reply
seanshowalter wrote on May 11 2014, 03:33 am

Good job on this. If you want to play the song without a capo you can play it like this:

A - C#m7 - Bm7

Those are the 3 chords in the tune that just repeat over and over again.

However, at the end of the second verse and second chorus, you can play an E chord too..depending on how close you want to be to the original.

Hope this helps. I just spent hours learning this tune.

Peace. :)

I want to post or [tab]
guest
You may want to rate the tab now too:
select rating
Please do not post tabs as comments. Select "correction" instead!